Drywall Repair in Brevard County

Holes happen. Doorknobs punch through walls. Water leaks leave stains and soft spots. Cracks show up along seams and corners as a house settles. None of it looks good, and none of it is hard to fix. If you know what you are doing.

We handle drywall repair as part of the painting process. The crew that patches your wall is the same crew that primes and paints it. That matters because drywall repair is really just painting prep done right. If the patch is sloppy, the paint will show it.

Small and medium holes

Small holes from nails, screws, and anchors are quick fixes. We fill them with lightweight spackle, sand flush, and prime. You will never know they were there.

Medium holes. Fist-sized or from a doorknob. Need a patch. We cut a clean opening, fit a new piece of drywall, tape the seams with paper or mesh tape, and apply two to three coats of joint compound. Each coat gets sanded smooth before the next one goes on. The goal is a perfectly flat surface with no visible seam lines.

Large holes and damaged sections

Large holes and damaged sections get a full cutback. We cut to the nearest studs on each side, install a new piece of drywall, and tape and mud the joints. For ceiling damage or areas larger than two feet, we may need to add backing supports. We build it back to match the surrounding wall exactly.

Water damage

Water damage is its own category. If drywall has gotten wet, we check for soft spots, mold, and structural damage behind the wall. Wet drywall loses its integrity. It sags, crumbles, and grows mold if it is not replaced. We cut out the damaged section, let the framing dry completely, treat for mold if needed, and install new drywall.

Matching existing texture

Texture matching is where most DIY repairs fall apart. Your walls probably have a specific texture. Orange peel, knockdown, skip trowel, or smooth. We match whatever is there so the repair disappears into the surrounding wall. We keep samples of the most common textures and can replicate just about anything we encounter.

Priming and finishing

After the repair is solid and the texture is matched, we prime everything with a stain-blocking primer. This seals the joint compound, evens out the porosity, and gives the finish paint a uniform surface to grip. Without primer, patches absorb paint differently than the surrounding wall and show through as dull spots. Even with two coats of paint.

Most drywall repairs take less than a day. Larger jobs or water damage work may take two days to allow for drying time between coats. We clean up after ourselves and leave the wall ready for its finish coat.

The bottom line is this: we fix the wall before we paint it. Every time. That is how you get a paint job that looks right and stays right.